New Improved Version
Treat your classic car to some modern technology with this useful variable intermittent windscreen wiper controller. Onboard potentiometer adjusts delay time between wiper sweeps from 3 to 40 seconds approx. Helps to reduce wiper chatter, improve safety and prolong the life of wiper blades and windscreen.
The operation is similar to that seen on most modern vehicles - Wipe > Park > Pause > Repeat. Wipers perform a single sweep, park then pause for the user-set delay period. The cycle automatically repeats until the wipers are turned off. The board does not offer a continuous sweep setting, only intermittent operation as described above.
Easily fitted to most 12V negative earth vehicles with self-parking wiper motors. Can be fitted to either front or rear screen wipers.
Just 4 connections are required:
We recommend that a 100mA safety fuse (Order Code 787.000UK) is fitted to the boards power input terminal (V+) using an inline fuse holder (Order Code 787.438UK).
Now available in two version:
Please note that we are unable to provide vehicle specific installation advice - refer to the user manual below and your vehicle wiring diagram or have an auto electrician install it for you.
FeaturesWorking voltage | 12-15Vdc from vehicle battery (negative earth) |
Current Consumption | Quiescent: < 10 mA Active: < 40 mA |
Frequency Adjustment | 2 to 20 operations per minute approx. |
Output Load | 5 Amp max. (as supplied) |
Board Dimensions | 40 x 60 x 20mm |
Enclosure | WCAH2853 (or WCAH2855 but not much space for wires) |
Control Knob | KB0295 |
Safety Fuse (recommended) | 787.250UK |
Fuse holder | 787.438UK |
Board Connections | Screw terminal blocks |
Product Formats | SELF-ASSEMBLY Electronic Kit (KT) or PRE-ASSEMBLED Electronic Module (AS) Product Formats Info |
Documentation | 8093 User Manual 8093SW User Manual |