This product is obsolete/discontinued and no further stocks are available. Please see alternatives in the category links above.
10 channel high security (rolling-code) UHF remote control relay board for use in a variety of applications. One receiver board can be used with up to 15 transmitter key fobs making it ideal for a multi-user access or control system.
Whether you want to control a garage door or gate, a car and/or home alarm, or perhaps remotely turn lights or anything else on or off, this system is just what you're looking for!
The Technical Documentation describes how key press combinations give readable outputs: pins 1, 2, 3, and 4 (of course) and the pins 1&2, 1&3, 1&4, 2&3, 2&4, and 3&4 pressed together. A pre-programmed PIC micro-controller handles the logic (source code is provided for educational purposes).
*The Receiver board defaults to Momentary Mode for all relays but can be changed to Toggle Mode by holding the button or keypress combination depressed for more than 2 seconds. That relay will stay in that mode until another >2 sec keypress is received (NB a firmware upgrade is available that changes this arrangement - see our Firmware Chips page for details). Small relays are used to save weight and board area.
The kit is supplied with all the components to build one complete 10 channel relay board (as pictured). One ready built 4-button keyring transmitter (with battery) is also supplied but up to 15 transmitter units can be learnt by one Rx unit. Extra transmitter units can be purchased separately (Order Code 30A16-Tx).
SpecificationsRelay Receiver Board | |
Supply | Regulated 12-15Vdc (Order Code 660.446UK with connector 777.001UK) |
Current consumption | Standby <8mA. Add approx 30mA for each active relay |
Switching Frequency | ~120 operations per minute maximum |
Output Type | 10 x SPDT Relays |
Maximum Output Load (Resistive) | Up to 110Vac or 24Vdc @ 1 Amp max. per relay (Relay Datasheet) |
Output Connections | NO, NC, C (Relay FAQ) |
Dimensions | 113 x 85 x 25 mm approx |
Enclosure | WCAH2851 |
Connections | Solder pads for relay connections but ..... Board will accept screw terminal blocks but these must be supplied by the purchaser unless the AS3181T version is purchased |
Key Fob Transmitter | |
Supply | 12Vdc battery (supplied) |
Dimensions | 50 x 35 x 15 mm approx |
Product Formats | SELF-ASSEMBLY Electronic Kit (KT) or PRE-ASSEMBLED Electronic Module (AS) Product Formats Info |
Documentation | User Manual 3181B Firmware Upgrade Documentation |