Quick Store Search
01279 467799 (M-F 8:30am - 5pm)Message Us

Shopping Cart 0 Items (Empty)

AS8093KT - Intermittent Windscreen Wiper Controller

Ability Level 2: ModerateProduct Formats Available : Pre-Assembled Module (AS) or
Self-Assembly Electronic Kit ( Soldering Required)

PRE-ORDER - Restocking week commencing 12 December 2016

Treat your classic car to some modern technology with this useful variable intermittent windscreen wiper controller. The variable wipe delay interval can be adjusted from 1 to 30 seconds using the onboard potentiometer.

Two modes of operation are available

  • Wipe-Park-Pause-Repeat (seen in most modern vehicles): wipers perform a single sweep, park then pause for the potentiometer-set delay period. This mode is activated using a separate input.
  • Cycling On-Off: wipers sweep continuously for the pot-set time then park and turn off for the same time.

Both modes repeat until turned off.

Easily fitted to any 12V vehicle with self-parking wiper motors. Relay is rated to switch up to 3 Amps.

Can help reduce wiper chatter, improve safety and prolong the life of wiper blades and windscreen.

Please note that we are unable to provide vehicle specific installation advice - refer to the user manual below and your vehicle wiring diagram or have an auto electrician install it for you.

  • Multilingual instructions supplied (GB,D,F,NL,I,E,H,GR)
  • Kit version includes solder for assembly
Working voltage12-15Vdc from vehicle battery
Current Consumption200 mA Maximum
Frequency Adjustment2 to 60 operations per minute approx.
Output Load3 Amp max.
Board Dimensions33 x 86 x 25mm
Control KnobKB0295
Board ConnectionsSolder Pads
Product FormatsSELF-ASSEMBLY Electronic Kit (KT) or
PRE-ASSEMBLED Electronic Module (AS) Product Formats Info
DocumentationUser Manual
You might also like . . .