This external signal (0-10Vdc) or potentiometer operated AC motor speed controller uses Phase Angle Regulation (PAR) and a triac output and allows you to adjust the speed of 230Vac 50Hz single-phase "universal" motors as used in power drills, vacuum cleaners, etc and an operating load of up to 1500 Watts.
Motor speed adjustment is from 0 to 100% is achieved using either an external 10K potentiometer (not included) or a 0-10V dc control signal.Please note that the dc control signal input floats at mains potential and may not therefore be suitable for some applications like connection to DMX systems (see CR026 for an alternative option).
Signal input operation can be set so the output is either directly or inversely proportional to the control signal.
Please see User Manual below for full description.
PRODUCT SELECTION NOTES: Suitable for controlling most 230Vac 50Hz single-phase "universal" motors, light regulators, 230V signals through automatisms, etc… NOT suitable for use with synchronous AC motors, capacitor-start/run AC motors or inductive loads like halogen or PL lamps, neon, etc.. Ask the manufacturer to confirm if their motor is suitable for control using a Phase Angle Regulation (PAR) style controller BEFORE you buy this product! The motor controller should have an output load capacity at least 25% above the motors peak power requirement. Please do NOT rely on motor rating plates for power consumption figures as they often quote average not peak power. You should verify the actual peak power at start-up and under full load before selecting an appropriate size motor controller.
Please see CR026 for a 2500W version of this product.
|Operating Voltage||230Vac 50Hz mains (the interference filter mentioned in the User Manual is optional and is not necessary in most installations)|
|Output Load||1500 Watts maximum|
|Control signal voltage||0 - 10V dc|
|External potentiometer||10K Ohm (Order Code RE.POT.10KLIN)|
|Output Load (Minimum)||50 Watts|
|Operating Voltage (Minimum)||90Vac|
|Board Dimensions (mm)||~ 72 x 98.75 x 45 mm|
|DIN Rail Mount||C7567|
|EMI Mains Filter||C8202|
|Product Format||PRE-ASSEMBLED Electronic Module Product Format Info|
|Documentation||Cebek R-21 User Manual|
|WARNING||This product operates at mains voltage. Connection, testing and use of the product should only be attempted by competent persons, or under supervision of someone fully experienced in this field. Many areas of the assembly (including heatsinks) may operate at mains voltage. It must be fitted into a suitable isolating enclosure to avoid injury or death. This product is not suitable for children. Mains Electricity Info|