HPS10SE - Personal Scope 10MS/s (SPECIAL EDITION)

The HPS10SE Personal Scope (SPECIAL EDITION) is not a graphical multimeter but a complete portable oscilloscope at the size and the cost of a good multimeter. Its high sensitivity - down to 0.1mV/div - and extended scope functions make this unit ideal for hobby, service, automotive and development purposes. Because of its exceptional value for money, the PersonalScope is well suited for educational use in schools and colleges.

It is suitable for measurements on audio equipment, mains voltage applications, digital signals, all kinds of sensors, signal analysis in automotive applications, car stereos, etc… Its full auto setup function makes it easy to measure waveforms.

Same as the HPS10, but with blue LCD, white backlight. Comes in a rigid carry case.

• 10MHz sampling rate
• 0.1mV sensitivity
• up to 2MHz analogue bandwidth
• 5mV to 20V/div in 12 steps
• 200ns to 1hour/div time base in 32 steps
• full auto set up
• trigger mode: run, normal, once, roll, slope +/-
• X and Y position signal shift
• DVM readout with x10 option
• audio power calculation (rms and peak)
• dBm, dBV, DC, RMS ... measurements
• signal markers for Volt and Time
• frequency readout (through markers)
• recorder function (roll mode)
• signal storage (2 memories)
• LCD: 128x64 pixels / high-contrast
• up to 20h on alkaline batteries (maximum size battery is 2000mA - bigger batteries will not fit)

• adapter 9V / 500mA (Order Code PSU444 is suitable)

• power supply: 5 x 1.5V AA battery or NiCd / NiMH (not incl.)
• includes battery charging circuit

• Oscilloscopes Cross Reference Table
• HPS10SE User Manual (English)